Yamaha TP-5029H 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Yamaha TP-5029H에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha TP-5029H 12 페이지. Pedal timpani
Yamaha TP-5029H에 대해서도 마찬가지입니다: 소유자 매뉴얼 (12 페이지), 소유자 매뉴얼 (12 페이지)

페이지 인쇄

Before Using The Pedal Timpani

Your Yamaha pedal timpani is equipped with a plastic head carefully mounted and tuned

(adjusted to a note) at the factory, and thus can be used after setup immediately. However,

new heads will tend to stretch gradually during shipping and storage, resulting in a tuning

deviation when you receive the instrument. Therefore, please perform the steps below to

restore the tuning to the factory setting prior to shipment:

The area between the kettle edge and the inner

circle of the counter hoop is called the collar.

Please make sure that the width of this collar is

uniform, as shown in the illustration titled "Cor-

rect".

Correct

Kettle

Counter

edge

hoop

Collar

If the collar is not uniform (illustration titled

"Wrong"), keep the heel of the pedal fully de-

pressed as shown in Fig. C, and align head and

hoop as shown in the illustration titled "Correct".

Make sure that the end of the wire tube is not

disengaged from the adjuster of the tuning indi-

cator as shown in Fig. A. If it is disengaged,

insert it into the adjuster as shown in Fig. B.

Fig. B

Wire tube

Wrong

Kettle

Counter

edge

hoop

Collar

Adjuster

Fig. A

If the heel of the pedal is fully lowered as in Fig.

C, proceed with step

If the pedal position is as shown in Fig. D or the

toe of the pedal is fully lowered, perform step

first.

Fig. C

Fig. D

Never put your hands etc. under the

Caution

pedal.

Fully depress the heel of the pedal as shown in

Fig. C. Hold the pedal in this position, as it will

return otherwise.