Yamaha TP-8300R series 소유자 매뉴얼 - 페이지 11

{카테고리_이름} Yamaha TP-8300R series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha TP-8300R series 14 페이지. Pedal timpani
Yamaha TP-8300R series에 대해서도 마찬가지입니다: 소유자 매뉴얼 (14 페이지)

페이지 인쇄

Tuning Indicator Adjustment

The tuning indicator shows where to set the pedal for each note. After tuning the instrument,

you must set each note on the indicator to its proper position.

After you have tuned your timpani to the low-

est note of its tonal range, make sure that the

pointer is located within 1/16" – 1/8" from the

pedal-side end of the indicator rail.

* If not, refer to "Adjusting the Pointer Position" .

Slide the lowest note name marker on the indi-

cator ("C" in the case of a 23" timpano*) to the

position where its center line coincides with the

pointer.

* "Usable Tonal Ranges for Yamaha Tim-

pani" on page 20.

Tune the instrument to the next highest pitch

(note) by moving the pedal, and then slide the

corresponding note name marker on the rail to

the respective pointer position. Repeat for each

remaining note.

Indicator Rail

Note Name

Marker

* The "B" marker can

be replaced with the

provided "H" marker

to m a t c h p l ay i n g

preferences.

Relocating the Tuning Indicator

The timpani is shipped with a universal style tun-

ing indicator already attached however, the tuning

indicator can be relocated for German style tuning.

Using the supplied hex wrench, remove the two

bolts holding the tuning indicator in place as

shown in the diagram (right), then slide the bolts

through the holes on the tuning indicator from the

opposite side. In either position, make sure that

the note indicator bridge is easily viewable.

Pointer

n Adjusting the Pointer Position

First loosen the pointer lock nut and then turn the

adjuster as follows:

• Pointer is located beyond the lower rail end

when the heel of the pedal is lowered fully

(lowest note).

g Turn the adjuster to the left (counter clockwise)

until the pointer is aligned with the lowest note

of the indicator.

• Pointer moves beyond the upper rail end

before the toe of the pedal reaches the end of

its stroke, or pointer does not reach the lower

rail end when the heel of the pedal is lowered

fully (lowest sound).

g Turn the adjuster to the right (clockwise) to

correct the pointer position as required.

Adjuster Cover

* Replace the

cover after

adjusting.

Adjuster

Universal Style

Attachment

Tuning

Indicator Bolt

Mounting Bracket

Note Name Marker

Pointer Lock Nut

German Style

Attachment

Tuning

Indicator Bolt