Yamaha Tuba 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Yamaha Tuba에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha Tuba 22 페이지. Alto/baryton/euphonium/tuba/sousaphone
Yamaha Tuba에 대해서도 마찬가지입니다: (프랑스어) Mode D'emploi (22 페이지)

페이지 인쇄

Before You Play

■ Assembling the Leadpipe

(Sousaphone only)

The sousaphone uses a multi-piece leadpipe.

This leadpipe in combination with a bit allows

the player to adjust the mouthpiece to a com-

fortable position to best fit individual needs.

Apply some slide grease to the middle sec-

tion of the leadpipe and then insert it into

the leadpipe receiver. Next, tighten the

screw on the receiver to secure the middle

pipe in place.

Bit

Receiver Screw

Mouthpiece

* If the bit is left on the leadpipe, it may

become stuck in place. After playing, make

sure that the bit is removed from the

leadpipe and remove moisture from the

bit.

* The YSH-411 is supplied with two different

bits. Both can be connected together if

necessary.

Leadpipe

Middle pipe

Leadpipe

receiver

■ Assembling the Marching Tuba

(Marching series only)

The leadpipe on one of the marching series tuba

models can be switched to convert the instru-

ment between marching use and regular con-

cert use. (An "M" at the end of the product num-

ber indicates a marching series tuba.)

Loosen screws A and B to remove the regu-

lar concert leadpipe, then attach the march-

ing leadpipe and tighten screws A and B.

Concert leadpipe

* The marching type mouthpipe may

become stuck or difficult to remove if left

in the tuba. Please use caution.

Insert the square support on the backside

of the instrument and use screw E to adjust

the leadpipe angle, then tighten screws C

and D to secure it.

Backside

Square support

Marching

leadpipe