Yamaha WX5 소유자 매뉴얼 - 페이지 30

{카테고리_이름} Yamaha WX5에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha WX5 44 페이지. Yamaha wind midi controller owner's manual

페이지 인쇄

Troubleshooting

PROBLEM

The LED indicators don't light when the power is

turned on.

No sound is produced when breath pressure is

applied to the WX5.

Volume too low, or it is too difficult to produce suf-

ficient volume.

Sound is produced even when no breath pressure

is applied to the WX5.

The pitch doesn't change as expected when lip

pressure is applied to the reed.

The volume doesn't change as expected when

breath pressure is varied.

POSSIBLE CAUSE/SOLUTION

• The Loose Lip mode is selected. When the Loose Lip mode is selected

the LED indicators may not light. This is normal.

• If the Tight Lip mode is selected, the lip sensor may not be adjusted

properly. Follow the adjustment procedure outlined on page 26.

• The wind sensor may not be properly adjusted. Follow the adjustment

procedure outlined on page 25.

• The Audition function may be turned on. Try turning the Audition func-

tion off as described on page 21.

• The tone generator power may be off, or its MIDI settings may be not be

set up properly for use with the WX5. Check your tone generator.

• The wind sensor may not be properly adjusted. Follow the adjustment

procedure outlined on page 25.

• The sensitivity (software wind gain) setting may be too low. Refer to

page 20.

• Also check the voice you are using as well as relevant tone generator

settings.

• If the LED2 indicator is lit when no breath pressure is applied, this may

mean that the wind sensor is not adjusted properly. Follow the adjust-

ment procedure outlined on page 25.

• The Key Hold function may be engaged. Try pressing the Key Hold but-

ton to disengage Key Hold.

• The Audition function may be turned on. Try turning the Audition func-

tion off as described on page 21.

• No lip pressure can be applied if you are using the reedless (recorder

type) mouthpiece. Use the reed (saxophone type) mouthpiece if you

want to use lip control.

• The setup switches related to lip sensor operation may not be set prop-

erly. Refer to the instructions for switches 1-6 and 1-7 on page 22, 23.

• The voice you have selected may not allow pitch control. Use a voice

that is set up to allow pitch control.

The volume control settings of the WX5 and tone generator may not be

matched properly. If the WX5 wind sensor is set to transmit breath data as

MIDI breath control data (control change #02), then the tone generator

must be set up to allow volume control via the same type of data. Either

change the WX5 wind sensor data type to match that of the tone genera-

tor (page 22), or set the tone generator to allow breath control.