Yamaha YDP-113 소유자 매뉴얼 - 페이지 29

{카테고리_이름} Yamaha YDP-113에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha YDP-113 44 페이지. Yamaha digital piano owner's manual
Yamaha YDP-113에 대해서도 마찬가지입니다: 빠른 작동 매뉴얼 (2 페이지), (프랑스어) Mode D'emploi (44 페이지)

페이지 인쇄

Keyboard Stand Assembly

CAUTION

Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor-

dance with the sequence given below.

• Assembly should be carried out by at least two persons.

• Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage.

• Be sure to tighten up all screws upon completing assembly of each unit.

• To disassemble, reverse the assembly sequence given below.

Have a Phillips-head (+) screwdriver ready

Remove the following parts from the package.

Assembly Parts

16 mm flat-head screws 8

Damper pedal

Attach the center panel (B) to the side

panels (C).

The center panel (B) is installed between the side pan-

els (C). The brackets on each end of the center panel

should face the rear of the stand assembly. Place the

square holes in the center-panel brackets over the lugs

extending from the side panels, then slide down the

center panel. Each side of the center panel is attached

using two 6 16 mm ﬂat-head screws.

6 x 16 mm flat-head screw

• Fingers can become pinched between the main

• Do not hold the keyboard in any position other

AC power cord

Cord holders 2

Install the main unit (A).

CAUTION

unit and the rear or side panels, be extra careful so

as not to drop the main unit.

than the position shown in the illustration.

Place the main unit (A) on the side panels (C) with the

screws on its bottom panel (toward the rear of the main

unit) just behind the grooves in the brackets located at

the top of the side panels. Then slide the main unit for-

ward until it stops.

Align the holes in the bottom panel of the main unit

with the holes in the brackets on the side panels. (Cen-

ter the main unit to produce equal clearance on the left

and right sides, as shown in the illustration.) Then use

the four 6 16 mm ﬂat-head screws to attach the main

unit. Two screws can be attached from the front side

and two screws from the rear.

10 cm

6 x 16 mm flat-head screw

Be sure to place your

hands at least 10 cm

from either end of the

main unit when posi-

tioning it.

NOTE

If the holes of the front side brackets are not aligned with the

screw hole, position the sides of the side panels so that they

are parallel with the side of the unit.

YDP-113

10 cm