Yamaha YDP-123 소유자 매뉴얼 - 페이지 29
{카테고리_이름} Yamaha YDP-123에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha YDP-123 44 페이지. Digitalpiano
Yamaha YDP-123에 대해서도 마찬가지입니다: 빠른 작동 매뉴얼 (2 페이지), (프랑스어) Mode D'emploi (44 페이지), (독일어) 사용 설명서 (44 페이지)
페이지 인쇄
Keyboard Stand Assembly
CAUTION
• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor-
dance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage.
• Be sure to tighten up all screws upon completing assembly of each unit.
• To disassemble, reverse the assembly sequence given below.
Have a Phillips-head (+) screwdriver ready
Remove the following parts from the package.
Assembly Parts
6
20 mm long screws 4
1
6
16 mm short screws 4
2
4
12 mm thin screws 2
3
Main unit
Side
panel
Rear panel
(left)
Pedal box
Bundled pedal
cord inside
A headphone hanger is included in the YDP-123 package.
You can attach a headphone hanger on the YDP-123 to hang
the headphones (page 12).
4
20 mm tapping screws 4
4
Cord holders
2
Side
panel
(right)
AC power cord
TIP
1.
Attach the side panels to the pedal box.
(2) Align the sides of the
Side panel
(left)
(3) Use the four
6 20 mm long
screws 1 to
attach the
pedal box.
(1) Untie and straighten out the bun-
dled cord attached to the bottom
of the pedal box.
Don't discard the vinyl tie, you'll
need it later in step 5.
2.
Attach the rear panel.
(1) Secure the top of the rear panel to
the side panel brackets using two
4 12 mm thin screws 3.
(2) Secure the bottom of the rear panel
to the pedal box using four 4 20
mm tapping screws 4.
YDP-123
pedal box with the left and
right side panels.
Side panel
(right)
Keyboard Stand Assembly
29