Yamaha YDP-143B 소유자 매뉴얼 - 페이지 30

{카테고리_이름} Yamaha YDP-143B에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha YDP-143B 36 페이지.

Yamaha YDP-143B 소유자 매뉴얼

Keyboard Stand Assembly

The illustrations here are taken from the YDP-143.
CAUTION
• Be careful not to confuse parts, and be sure to install all
parts in the correct orientation. Please assemble the unit in
accordance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Assemble the unit on a hard and flat floor with ample space.
• Be sure to use the included screws only, and insert screws
of the correct size in the correct hole locations. Use of
incorrect screws can cause damage or malfunction of the
product.
• Be sure to tighten all screws upon completing assembly of
the unit.
• To disassemble, reverse the assembly sequence given
below.
Have a Phillips-head (+) screwdriver of the appropriate size
ready.
Remove all parts from the package and make sure you
have all of the items.
Cord holder
D
Bundled pedal cord inside
AC adaptor
Power cord
(YDP-163)
(YDP-163)
* The adaptor may not be included, or may look different from the
illustration above, depending on your particular area. Please
check with your Yamaha dealer.
Screws set
1
6 x 20 mm
long screws x 4
2
6 x 16 mm
short screws x 4
Headphone hanger set (YDP-163 only)
4×10 mm thin screws
30
YDP-163/YDP-143 Owner's Manual
A
E
B
C
AC adaptor
(YDP-143)
3
4 x 12 mm
thin screws x 2
4
4 x 20 mm
tapping screws x 4
Headphone hanger
1.
After untying the bundled pedal
cord on C, attach C to D and E and
fasten the screws (1-3).
E
1 - 2
C
1 - 3
1-1
Untie and straighten out the bundled pedal
cord.
Untie the two vinyl strings.
1-2
Align D and E with each end of C.
1-3
Attach D and E to C by finger-tightening
the long screws
1
D
1 - 1
C
(6 x 20 mm).