Yamaha YM-41 소유자 매뉴얼 - 페이지 16

{카테고리_이름} Yamaha YM-41에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha YM-41 20 페이지. Concert marimbas
Yamaha YM-41에 대해서도 마찬가지입니다: 소유자 매뉴얼 (19 페이지)

YM-410D

ASSEMBLY

Insert the rails (2), (3) and (4) into the frame ends of the legs.

2-1. First, insert the rail (2). Make sure that the end of the rail with the tone bar posts spaced

further apart is positioned on the bass side.

A mark "B" is printed on the large end face of the rail (2) and the groove section of the

frame end of the large end leg.

* Do not insert one side of the rail all the way down first, but push both sides into grooves alter-

nately little by little until both sides are inserted fully and stop.

Rail (4): With YAMAHA logo. Logo side facing the audience.

High register side

2-2. After confirming that legs on the left and right sides are vertical, use

the screw to connect the end of the stay to the hole for attaching

the stay in the long frame (2) and firmly tighten the screw.

2-3. Next, in the same way, insert the rails (3) and (4) securely.

A mark "C" is printed on the large end face of the rail (3) and the

groove section of the frame end of the large end leg, and a mark "D"

for the rail (4).

2-4. Engage the short rail clamp located

at the center of the rail (3) with the

rail (2).

(3): Both sides have clamps attached. The side with the shorter clamp should face the player.

(2): Hole for attaching the stay. The side with the threaded hole should face the audience.

Audience side

(1)

Tone bar posts

Slant shaft

Player side

Frame end

Bass side

Rail (2)