Yamaha YM-410 소유자 매뉴얼 - 페이지 18

{카테고리_이름} Yamaha YM-410에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha YM-410 19 페이지. Concert marimbas
Yamaha YM-410에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지)

YM-410D

ASSEMBLY

Insert the rail (1) into the frame ends of the legs.

4-1. Insert the outer rail (1) in the same way as the inner rails (2), (3) and (4).

A mark "A" is printed on the large end face of the rail (1) and the groove section of the frame end of

the large end leg.

Set the tone bars.

5-1. While adjusting the long frame, engage the rail clamp on rail (2) and rail (3) with rail (1) and rail (4),

respectively.

Rail clamp

Rail (4)

5-2. Set the natural tone bars first.

Align each tone bar individually and hook its

After confirming that the

s forward from the large end side and hooking the two springs into each other.

* When setting the tone bars, use care not to cause any damage to them.

Small end

Once again, confirm that all screws are tightened firmly.

Rail clamp

onto the corresponding tone bar post.

is secured to every post, fix the tone bars by pulling the right and left

Large end

Suspension cord

Rail (1)

Rail (2)

Rail (3)

Suspension cord

Springs