Yamaha YM-46 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Yamaha YM-46에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha YM-46 20 페이지. Concert marimbas
Yamaha YM-46에 대해서도 마찬가지입니다: 소유자 매뉴얼 (19 페이지)

YM-460/460F/410/410F/46/41/2400/2400R

ASSEMBLY

Attach the resonators.

3-1. Assemble the resonator pipes of the YM-460/460F/410/410F/46/2400/2400R. Make sure that the

natural tone and accidental tone sides are properly assembled. All pipes on the natural tone side

have bottoms attached.

3-2. Insert the resonators into the resonator holders on the frame ends in the same way as the rails.

Place the bass side of the resonators into the center grooves on the resonator holder.

* Make sure not to confuse the natural tone resonators and accidental tone resonators.

* Take care not to bump the resonators against the legs, etc.

* The resonators are factory adjusted so that the optimum resonance level is obtained at 23°C (73.4°F) If

desirable resonance is not available due to the temperature lower or higher than 23°C (73.4°F), adjust

setting of the resonators. Move the resonators to fit into shorter grooves when the temperature is higher and

into longer grooves when the temperature is lower.

Temperature

Higher

Around 23°C (73.4°F) Center groove ("B")

Lower

Grooves to use

Short groove ("A" in the figure below)

Long groove ("C")

A : For a higher temperature

B : For a temperature around 23°C (73.4°F)

C : For a lower temperature

Resonators

(Accidental tone side)

Resonators

(Natural tone side)

Resonator holder