Yamaha YM-460F 소유자 매뉴얼 - 페이지 12

{카테고리_이름} Yamaha YM-460F에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha YM-460F 20 페이지. Concert marimbas
Yamaha YM-460F에 대해서도 마찬가지입니다: 소유자 매뉴얼 (19 페이지)

페이지 인쇄

YM-460/460F/410/410F/46/41/2400/2400R

ASSEMBLY

YM-460/460F/410/410F/2400/2400R Only

Adjust the height of the tone bars.

Make sure that this procedure is performed by at least two persons.

Reverse the assembly procedure going from steps b → v → c and remove the resonators and the

stay fixing bolts attached to the rail section (2) so that the stays can be moved.

With two persons, hold the instrument under the frame on both bass and treble sides, and loosen the

wing screws that lock the slide legs in place.

After determining the desired height, tighten the wing bolts so they fit into the channels on the slide

legs firmly fixing the legs in place. Use the next channel above as a guide to make sure the tone bars

are parallel with the floor.

Upon completion of assembly, check to make sure that each bolt is tightened securely.

When a slide leg fixing bolt is tightened in between two notches, there is a danger

of the slide leg slipping. Always make sure that the slide legs are held securely.

* Never attempt to adjust the height with the tone bars in place. It is very dangerous. Always make

sure that those parts are removed as described in the procedure above before adjusting the

height.

Align notch with

upper flange.

Do not touch the notched part during

height adjustment to avoid injury.

Slide leg