Yamaha YV-2700G 소유자 매뉴얼 - 페이지 20

{카테고리_이름} Yamaha YV-2700G에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha YV-2700G 28 페이지. Concert vibraphones
Yamaha YV-2700G에 대해서도 마찬가지입니다: 소유자 매뉴얼 (28 페이지), 소유자 매뉴얼 (29 페이지), 소유자 매뉴얼 (34 페이지)

페이지 인쇄

ASSEMBLY: YV-3910/3710/3700

10-4 Tone Bar Height Adjustment

This adjustment should always be performed by at least 2 persons.

To adjust the height of the tone bars, first remove the synchro belt, driver, controller,

tone bars, and resonators in the reverse order of steps

loosen the center rod fixing bolts.

Loosen the slide leg fixing bolts on the high and low sound sides, while supporting the

frame ends by hand.

Lift the frame ends to the desired height and then securely tighten each fixing bolt,

aligning it with the corresponding notch of the slide leg. Bolt and notch are aligned

when the next higher notch is flush with the upper leg flange.

After assembly, confirm that each bolt and screw is tightened securely.

Align notch with

upper flange.

When a slide leg fixing bolt is tightened in between two notches,

there is a danger of the slide leg slipping. Always make sure

that the slide legs are held securely.

Slide Leg

Do not touch the notched

part during height adjust-

ment to avoid injury.

* The fourth notch from top

corresponds to the standard

height setting.

, and