Yamaha YV-3910 소유자 매뉴얼 - 페이지 14
{카테고리_이름} Yamaha YV-3910에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha YV-3910 28 페이지. Concert vibraphones
Yamaha YV-3910에 대해서도 마찬가지입니다: 소유자 매뉴얼 (28 페이지), 소유자 매뉴얼 (29 페이지), 소유자 매뉴얼 (34 페이지)
페이지 인쇄
ASSEMBLY: YV-3910/3710/3700
z Loosen the center rod fixing bolts to
3-3
extend the center rod.
x Connect the center rod with the fit-
ting of the rod connector by firmly
holding the center rod while turning
the rod connector.
c Tighten the rod connector until it
stops, and then secure with the lock
nut.
v
Attach the resonators.
4-1
Insert the resonators from underneath the frame and rest the high sound side and then the
low sound side onto the resonator holders (rubber).
*
Make sure not to confuse the natural tone side and accidental tone side resonators.
*
Take care not to bump the resonators against the legs etc.
Low Sound
Side
Accidental Tone
Side Resonators
To engage the low sound side, lift it over the
2
resonator holders and then insert it into the gap
between the two holders, as shown in the
illustration.
Resonator
Holders
12
x
z Loosen
Center Rod Fixing Bolt
z
1
First, place the high sound side onto the corre-
sponding resonator holders.
Rod Connector
x Turn
(screw on)
Lock Nut
c Secure
Center Rod
Knurled Part
z Loosen
Pedal Rod
High Sound
Side
Resonator
Holders