Yamaha YV-520 소유자 매뉴얼 - 페이지 25
{카테고리_이름} Yamaha YV-520에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha YV-520 28 페이지. Concert vibraphones
Yamaha YV-520에 대해서도 마찬가지입니다: 소유자 매뉴얼 (28 페이지), 소유자 매뉴얼 (29 페이지), 소유자 매뉴얼 (34 페이지)
페이지 인쇄
8
Connect the slide legs with the legs.
Align the legs from above so that the slide legs slide into the corresponding leg holes. Adjust
to the desired height and then securely tighten each slide leg fixing bolt, aligning it with the
corresponding notch of the slide leg. Fixing bolt and notch are aligned when the next lower
notch is flush with the upper leg flange.
Align notch
with upper
flange.
Do not touch the notched
part during height adjust-
ment to avoid injury.
* The fourth notch from the tone bar side
corresponds to the standard height
setting.
When a slide leg fixing bolt is tightened in between two notches,
there is a danger of the slide leg slipping. Always make sure
that the slide legs are held securely.
9
After fixing the legs, connect the pedal
with the sustain damper.
For YV-2700/2700G:
z
Loosen the center rod fixing bolts
to extend the center rod.
x
Connect the center rod with the
fitting of the rod connector by
firmly holding the center rod while
turning the rod connector.
c
Tighten the rod connector until it
stops, and then secure with the
lock nut.
ASSEMBLY : YV-2700/2700G/1600A/520
High
Sound
Side
z
Loosen
Center Rod Fixing Bolt
Low
Sound
Side
Rod Connector
x
Turn
(screw on)
Lock Nut
c
Secure
Center Rod
Knurled Part
z
Loosen
Pedal Rod
23