CALI alumLEDs ALS600T-AD Series 설치 매뉴얼 - 페이지 5
{카테고리_이름} CALI alumLEDs ALS600T-AD Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CALI alumLEDs ALS600T-AD Series 11 페이지.
페이지 인쇄1.
Measure area where luminaire will be installed. Use a chalk line to ensure a straight installation.
2.
Determine number of mounting arms needed. Use a minimum of two mounting arms per
fixture. Mount arms 6" from center of mounting plate to end of fixture.
Refer to spacing diagrams for details.
3.
Mark location where mounting arms will be installed. Screw arms to desired surface using
proper drill bit for surface and screw size.
4.
Snap fixture into mounting bracket and install set screws on both sides. Ensure fixture is
secured in place, and spacing is accurate according to the spacing diagram.
Set Screw
5.
Loosen set screw until the mounting bracket can move freely. Turn the mounting bracket
until desired angle is achieved, then mate the locking bump with locking hole. Tighten set
screw until mounting bracket is secured in place.
Set Screw
Locking Bump
CALIFORNIA ACCENT LIGHTING, INC.
2820 E. Gretta Lane, Anaheim, CA 92806
ph. 800.921.CALI (2254) | fx. 714.535.7902 | [email protected] | calilighting.com
© CALI. All rights reserved. CALI reserves the right to make changes or withdraw specifications without prior notice.
2019.12.5 Rev 2
Mounting Bracket
Locking Hole
-30°
-15°
0°
15°
30°
45°
60°
75° 90°
105°
Angle Increments
ALS600T-AD
6.
If applicable, connect disconnects between fixtures. Push and twist cap to lock connector.
Note: Shrink tube required for wet location installations.
ASSEMBLED END VIEW
2.00"
X" (Specify Length)
Add 0.93" to overall height for fixtures with louver installed
SPACING DIAGRAMS
2'8"
6"
Mounting Arms
3'8"
4'
Example: 4' Fixture
6"
2'8"
Mounting Arms
3'8"
4'
Example: 8' Fixture (4' + 4')
2'8"
6"
Mounting Arms
3'8"
4'
Example: 11' Fixture (4' + 4' + 3')
210°
195°
180°
165°
150°
135°
120°
ALS600T-AD-AA-BM-X
Shrink Tube
Apply Heat
4.61"
6"
6"
6"
2'8"
6"
Mounting Arms
3'8"
4'
8'
2'8"
6"
6"
6"
6"
Mounting Arms
3'8"
4'
11'
alumLEDs
Manufactured in the U.S.A.
Page 5 of 11
INSTALLATION
1'8"
6"
2'8"
3'
™