Yamaha Electone HS-8 소유자 매뉴얼 - 페이지 13

{카테고리_이름} Yamaha Electone HS-8에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha Electone HS-8 20 페이지. Serie hs monitor da studio alimentato e subwoofer alimentato
Yamaha Electone HS-8에 대해서도 마찬가지입니다: 소유자 매뉴얼 (2 페이지), 소유자 매뉴얼 (2 페이지), 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (21 페이지), 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (20 페이지), 서비스 매뉴얼 (43 페이지), (영어) 사용 설명서 (20 페이지)

Troubleshooting

Symptom

Power won't turn on /

The power cord might not be connected

front panel logo

properly.

doesn't light.

The power switch might not be turned on.

No sound.

One or more cables might not be

connected properly.

The source equipment might not be

supplying an audio signal.

The level setting might be too low.

Are cables connected to both the XLR and

phone jack INPUT connectors?

Noisy or distorted

One or more cables might be corroded,

sound.

shorted, or otherwise broken.

The system might be picking up external

noise.

Possible Cause

Solution

Check and connect the power cord.

Turn the power switch ON. If the problem persists,

contact your Yamaha dealer.

Check that all cables are properly connected.

Make sure that the source equipment is

functioning properly and delivering the required

signal.

Adjust the output level setting of the source

equipment, or use the LEVEL control to increase

the output level.

The XLR and phone jack input connectors can not

be used simultaneously. Use only one input

connector at a time.

Replace faulty cable(s).

Try changing the positions or layout of the cables.

Try changing the location of other electrical/

electronic devices that are near the speakers.

HS8/HS7/HS5/HS8S Owner's Manual