Yamaha EX5 보충 설명서 - 페이지 2

{카테고리_이름} Yamaha EX5에 대한 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha EX5 4 페이지. Yamaha ex5 synthesizer: supplementary guide
Yamaha EX5에 대해서도 마찬가지입니다: 소유자 매뉴얼 (41 페이지)

페이지 인쇄

Velocity Switching

This setup will produce a piano or brass sound

depending on how hard you play on the keyboard.

1: Go to the Performance Job mode and execute the Init

Perf function (manual page 173).

2: Engage the Performance Edit mode, press [F3] to go

to the "MLT" (Multi) display, and assign the "P1-001

Natural Grnd" piano voice to Part 1 (manual page

171).

3: Assign the "P1-065 Sect" brass voice to Part 2.

4: Scroll down to the Part 2 "Layer Sw" parameter and

turn it "On".

5: Scroll down to the "VelLmt L" parameter and set the

Part 2 low velocity limit value to 101.

6: Set the Part 1 "VelLmt H" parameter to 100.

Volume

Part 1

Vel Limit High = 100

Split With Arpeggiator

This example illustrates how the EX Arpeggiator can be

used with a split voice.

1: Go to the Performance Job mode and execute the Init

Perf function (manual page 173).

2: Engage the Performance Edit mode, press [F3] to go

to the "MLT" (Multi) display, and assign the "P2-027

CombiComp" voice to Part 1 (manual page 171).

3: Assign the "P2-010 BrethChoir" voice to Part 2.

4: Scroll down to the "Nt Lmt H" parameter and set the

Part 1 high note limit value to "B2".

5: Set the Part 2 "Nt Lmt L" parameter to "C3".

6: Go to the "COM/ARP" (Common/Arpeggiator) display

and set the Arpeggiator "NoteLim H" parameter to

"B2" (manual page 160).

7: Select the "041 [PulsLine]" Arpeggiator type.

You should now be able to play the choir voice normally

on all keys to the right of and including C3, while the

Arpeggiator will apply only to the "CombiComp" voice

played on all keys to the left of C3.

Part 2

127

Vel Limit Low = 101

Layers & Voice Response

EX voices themselves can have from one to four

layered elements. Up to 2 of these voices can then be

combined (layered or split) in the EX Performance mode

for even greater depth and richness. There are

limitations, however, and the following points should be

kept in mind when combining voices in the Performance

mode.

Number of Elements

When two voices which use a large number of element

layers are combined in the Performance mode, the extra

processing power required can result in sluggish

response when notes are played on the keyboard. This

may be particularly noticeable on percussive voices

which depend on a rapid attack for their sound. If this

problem occurs, try combining voices which use fewer

elements. The number of elements used by each voice

appears in the upper left-hand corner of the Voice Edit

display.

EL1