Yamaha EX7 소유자 매뉴얼 - 페이지 18
{카테고리_이름} Yamaha EX7에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha EX7 41 페이지. Yamaha ex5 synthesizer: supplementary guide
Yamaha EX7에 대해서도 마찬가지입니다: 보충 설명서 (4 페이지)
페이지 인쇄
raised, the noise produced during conversion will decrease, but the high
frequency range will be cut.
<Sampling Rate>
Specify the sampling frequency after conversion. The available range is
11,000Hz-64,000Hz.
5.8. Convert Bit Size ...
This command converts the sample size (number of bits) of the sound data.
5.9. Add Channel...
This command adds a silent channel to the currently open sound data. If you
execute the [Add Channel...] command on monaural data, it will become stereo
data with one side of silence.
5.10. Delete Channel...
This command deletes the specified channel from multi-channel sound data. If
you execute the [Delete Channel...] command on stereo data, it will become
monaural data.
5.11. Swap Channels...
This command exchanges the waveforms of two specified channels within multi-
channel sound data.
5.12. Import From Sampler...
When an external Yamaha sampler (A3000/4000/5000, EX5/5R/7) is connected via
SCSI, this command loads sound data from the sampler into TWE.
*If you are using an A3000/4000/5000, you must first select MIDI function in
Utility mode, and turn off the Bulk Dump Protect setting.
* If you are using an EX5/5R/7, only those samples which are stored in DRAM
can be transmitted to TWE. Samples stored in FLASH cannot be transmitted. If
you wish to transmit samples stored in FLASH to TWE, you must execute the
Copy Sample function on the EX to copy the desired sample from FLASH to
DRAM, and then execute TWE's [Import From Sampler...] command.
- 4 -