Yamaha H01 소유자 매뉴얼 - 페이지 23
{카테고리_이름} Yamaha H01에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha H01 30 페이지. Quick operation guide
Yamaha H01에 대해서도 마찬가지입니다: 빠른 작동 매뉴얼 (2 페이지)
페이지 인쇄
2.
Raise A to the vertical position.
2-1
Raise A to the vertical position, with the keyboard
side on the bottom, and hold A securely.
CAUTION
Do not release A until you
finish Step 4.
A A
CAUTION
Do not tip A further than 90 degrees to avoid stress to the
key cover and lid.
3.
Attach B.
3-1
Align the holes on A with those on B and hold A
and B together.
3-2
Finger-tighten six short screws (6x20 mm) start-
ing with the top hole.
3-3
Tighten the screws securely.
A
A
4.
Attach C.
4-1
Hold C so that the notch on the bracket will face
toward left, then align the holes on A with those
on C.
4-2
Finger-tighten four short screws (6x20 mm) start-
ing with the top hole.
4-3
5.
5-1
5-2
B
B
5-3
Hold E securely to avoid slippage.
Tighten the screws securely.
A
Assemble the pedal structure.
Pass the pedal cord (that comes out from the rear
of pedal box E) through a hole on the bracket of
D, then pass it through the pipe.
D
E
E
Align the holes on the bottom of E with the holes
on the bracket of D, then attach E and D by tight-
ening six small screws (4x6 mm). At this time,
first tighten the two center screws, then tighten
the rest of the screws.
Pull the end of the pedal cord to eliminate any
slack inside the bracket on D.
D D
E
CAUTION
Keyboard Stand Assembly
C C
23
H01 Owner's Manual