Yamaha piaggero NP-11 소유자 매뉴얼 - 페이지 7
{카테고리_이름} Yamaha piaggero NP-11에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha piaggero NP-11 28 페이지. Quick operation guide
Yamaha piaggero NP-11에 대해서도 마찬가지입니다: 참조 (7 페이지), 빠른 작동 매뉴얼 (2 페이지)

Setting Up
Be sure to do the following operations BEFORE turning on the power.
Introduction
Power Requirements
Although the instrument will run either from an optional AC adaptor or batteries, Yamaha recommends use of an
AC adaptor whenever possible. An AC adaptor is more environmentally friendly than batteries and does not
deplete resources.
Using an AC Power Adaptor
1 Make sure that the [
the instrument is off (the power indicator located to
the left of the switch is off).
WARNING
• Use the specified adaptor (page 22). The use of other
adaptors may result in irreparable damage to both the
adaptor and the instrument.
2 Connect the AC adaptor to the power supply jack.
3 Plug the AC adaptor into an AC outlet.
CAUTION
• Unplug the AC Power Adaptor when not using the
instrument, or during electrical storms.
2
Using Batteries
1 Open the battery compartment cover located on the
instrument's bottom panel.
2 Insert six new alkaline batteries, being careful to
follow the polarity markings on the side of the
compartment.
3 Replace the compartment cover, making sure that it
locks firmly in place.
NOTE
• Never connect or disconnect the AC power adaptor when the power is on
and the batteries are installed. Doing so will turn the power off.
] (Standby/On) switch of
3
AC power
AC outlet
adaptor
For battery operation, the instrument requires six 1.5V
"AA" size, LR6 or equivalent batteries. (Alkaline bat-
teries are recommended.) When battery power
becomes too low for proper operation, the volume
may be reduced, the sound may be distorted, and other
problems may occur. When this happens, make sure to
replace all batteries, following the precautions listed
below.
WARNING
• Make sure to install the batteries with the proper orienta-
tion, maintaining the correct polarity (as shown). Incorrect
battery installation may result in heat, fire and/or leaking of
corrosive chemicals.
• When the batteries run down, replace them with a com-
plete set of six new batteries. NEVER mix old and new bat-
teries. Do not use different kinds of batteries (e.g. alkaline
and manganese) at the same time.
• If the instrument is not to be used for a long time, remove
the batteries in order to prevent possible fluid leakage and
damage to the instrument.
NP-31/NP-11 Owner's Manual
7