Yamaha PORTATONE KB-280 서비스 매뉴얼 - 페이지 10
{카테고리_이름} Yamaha PORTATONE KB-280에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha PORTATONE KB-280 47 페이지. Service manual
Yamaha PORTATONE KB-280에 대해서도 마찬가지입니다: 설치 매뉴얼 (24 페이지)
페이지 인쇄
KB-280
5.
DMLCD Circuit Board, Back Light Assembly
and LCD
(Time required: About 4 minutes)
5-1
Remove the lower case assembly. (See procedure 1.)
5-2
Remove the LCD unit. (See procedure 4.)
5-3
Remove the eight (8) screws marked [L100]. The
DMLCD circuit board can then be removed from
the LCD unit. (Fig. 7)
5-4
Remove the LCD, back light assembly and rubber
connectors from the LCD panel. (Fig. 7)
*
When attaching the rubber connector to the
LCD panel, set the conductor side to face
inward. (Fig. 8)
*
When installing the DMLCD circuit board,
tighten the screws 1 through 8 in numerical
order as shown in Fig. 9. (Fig. 9)
If the DMLCD circuit board is replaced, execute
the "Factory Set" in the test program.
[L100]
[L100]: Bind Head Tapping Screw-P 3.0X12 MFZN2W3 (WE972900)
<Bottom view>
10
Nonwoven fabric cloth
LCD panel
LCD
Back light assembly
Rubber connector
LCD holder
DMLCD
(Fig.7)
[210J]
[210J]
[210J]
PNR
(PN 1/6)
[210]: Bind Head Tapping Screw-B 3.0X8 MFZN2W3 (WE774300)
6.
MIDI Circuit Board
(Time required: About 6 minutes)
6-1
Remove the lower case assembly. (See procedure 1.)
6-2
Remove the four (4) screws marked [210G]. The
MIDI circuit board can then be removed. (Fig. 5)
7.
PNL Circuit Board
(Time required: About 6 minutes)
7-1
Remove the lower case assembly. (See procedure 1.)
7-2
Remove the AM circuit board. (See procedure 3.)
7-3
Remove the eleven (11) screws marked [210H] and
two (2) screws marked [210I]. The PNL circuit board
can then be removed. (Fig. 10)
[210H]
[210K]
[210K]
[210H]
PNR
PNL
(PN 3/6)
(PN 2/6)
(Fig.10)
Rubber connector
Conductor side
Rubber connector
(Fig.8)
3
4
5
6
DMLCD
1
7
8
2
(Fig.9)
PNL
[210H]
(PN 4/6)
PB
(AMJK 6/6)
[210I]
[210N]