Yamaha PortaTone PSR-310 공인 제품 설명서 - 페이지 8

{카테고리_이름} Yamaha PortaTone PSR-310에 대한 공인 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha PortaTone PSR-310 42 페이지. Yamaha electric keyboard owner's manual
Yamaha PortaTone PSR-310에 대해서도 마찬가지입니다: 조립 지침 (1 페이지), 소유자 매뉴얼 (41 페이지), 소유자 매뉴얼 (40 페이지), (영어) 사용 설명서 (29 페이지)

페이지 인쇄

Supplying Power to your Keyboard

Your PSR-210 or PSR-310 will run either from an optional power adaptor or batteries. Follow the instructions

below according to the power source you intend to use.

Connecting a Power Adaptor

The PSR-210 or PSR-310 can be powered from an optional power adaptor. To connect a power adaptor follow

the steps below.

Inserting Batteries

The PSR-210 or PSR-310 can also be powered from six 1.5V D size (SUM-1 or R-20) or equivalent batteries.

To connect a power adaptor:

1. Make sure that the POWER switch of the keyboard is turned

off, and that the power adaptor is not plugged into a wall outlet

or power strip.

2. Plug the power adaptor's DC IN plug into the DC IN jack at the

rear of the PSR-210 or PSR-310.

3. Plug the power adaptor into a wall outlet or power strip.

Warning:

Use ONLY a Yamaha PA-3, PA-4 or PA-40 AC Power Adaptor to power your

instrument from the AC mains. Other adaptors may cause serious damage to

your PSR-210 or PSR-310, and your power adaptor

To insert batteries:

1. Make sure that the POWER switch is turned off.

2. Open the battery compartment cover located on the keyboard's

bottom panel.

3. Insert the six batteries, being careful to follow the polarity

markings on the cabinet.

4. Replace the compartment cover, making sure that it locks

firmly in place

No Power will be drawn from the batteries when power adaptor is used.

Warnings:

When the batteries run down the sound of your PortaTone may be dis-

torted. Replace them with a complete set of six new batteries. NEVER

mix old and new batteries together.

Do not use different kinds of batteries at the same time.

During battery replacement the PSR-210 and PSR-310 memory will be

backed up for approximately 1 minute. If the batteries are removed for a

longer period, the keyboard will revert to its default factory settings.