CALI ALS600T-AD-AA-BM Series 설치 매뉴얼 - 페이지 4
{카테고리_이름} CALI ALS600T-AD-AA-BM Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CALI ALS600T-AD-AA-BM Series 11 페이지.
CALI ALS600T-AD-AA-BM Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (2 페이지)
페이지 인쇄1.
Measure area where luminaire will be installed. Use a chalk line to ensure a straight installation.
2.
Mark location where mounting clips will be installed along chalk line.
3.
Use 2 mounting clips for each fixture.
4.
Lay mounting clips and pre-drill using proper drill bit for surface and screw size.
Recommendation: 8/32 x 1" screw.
Note: Allow 0.25" clearance for lateral expansion of assembled mounting clips.
Only install mounting clips on flat, even surfaces.
5.
Screw mounting clips to surface, then snap fixture into mounting clips. Install set
screws if needed. Set screws are required for downward and outward facing applications.
Set Screw
CALIFORNIA ACCENT LIGHTING, INC.
2820 E. Gretta Lane, Anaheim, CA 92806
ph. 800.921.CALI (2254) | fx. 714.535.7902 | [email protected] | calilighting.com
© CALI. All rights reserved. CALI reserves the right to make changes or withdraw specifications without prior notice.
2019.12.5 Rev 2
4'
Mounting Clip
2"
2"
3'
2"
2"
2'
2"
2"
1'
2"
2"
ALS600T-AD
ASSEMBLED END VIEWS
2.55"
2.89"
Without Louver (Closed)
3.56"
4.12"
Without Louver (Open)
alumLEDs
Page 4 of 11
INSTALLATION
Mounting Clips
2.65"
3.82"
With Louver (Closed)
4.49"
4.22"
With Louver (Open)
Manufactured in the U.S.A.
™