Yamaha YPT-230 소유자 매뉴얼 - 페이지 8

{카테고리_이름} Yamaha YPT-230에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha YPT-230 48 페이지. Digital keyboard
Yamaha YPT-230에 대해서도 마찬가지입니다: 데이터 목록 (3 페이지), 소유자 매뉴얼 (50 페이지), 소유자 매뉴얼 (50 페이지), 소유자 매뉴얼 (50 페이지), 소유자 매뉴얼 (50 페이지)

페이지 인쇄

Setting Up

Introduction

Be sure to do the following operations BEFORE turning on the power.

Power Requirements

Although the instrument will run either from an optional AC adaptor or batteries, Yamaha recommends use of an

AC adaptor whenever possible. An AC adaptor is more environmentally friendly than batteries and does not

deplete resources.

Using an AC Power Adaptor

1 Make sure that the [

instrument is off (display is blank, except for nota-

tion staff).

WARNING

• Use the specified adaptor (page 42). The use of other

adaptors may result in irreparable damage to both the

adaptor and the instrument.

2 Connect the AC power adaptor to the power supply

jack.

3 Plug the AC adaptor into an AC outlet.

CAUTION

• Unplug the AC Power Adaptor when not using the

instrument, or during electrical storms.

AC power

Using Batteries

1 Open the battery compartment cover located on the

instrument's bottom panel.

2 Insert the six new alkaline batteries, being careful

to follow the polarity markings on the side of the

compartment.

3 Replace the compartment cover, making sure that it

locks firmly in place.

NOTICE

• Never connect or disconnect the AC power adaptor when the

batteries are installed in the instrument and the power is on.

Doing so will turn the power off.

PSR-E233/YPT-230 Owner's Manual

] (Standby/On) switch of the

AC outlet

adaptor

For battery operation the instrument requires six 1.5V

"AA" size, LR6 or equivalent batteries. (Alkaline batter-

ies are recommended.) When battery power becomes too

low for proper operation, the volume may be reduced, the

sound may be distorted, and other problems may occur.

When this happens, make sure to replace all batteries,

following the precautions listed below.

WARNING

• Make sure to install the batteries with the proper orientation,

maintaining the correct polarity (as shown). Incorrect battery

installation may result in heat, fire and/or leaking of corrosive

chemicals.

• When the batteries run down, replace them with a complete set of

six new batteries. NEVER mix old and new batteries. Do not use

different kinds of batteries (e.g. alkaline and manganese) at the

same time.

• If the instrument is not to be in use for a long time, remove the

batteries from it, in order to prevent possible fluid leakage from

the battery.

NOTE

• Use alkaline batteries for this instrument. Other types of bat-

teries (including rechargeable batteries) may have sudden

drops of power when battery power becomes low.