Yamaha HTR-4063BL 빠른 참조 매뉴얼 - 페이지 6
{카테고리_이름} Yamaha HTR-4063BL에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha HTR-4063BL 9 페이지. Setup guide
Yamaha HTR-4063BL에 대해서도 마찬가지입니다: 간편한 설정 매뉴얼 (8 페이지)
페이지 인쇄5
5
Set up the speaker parameters automatically (YPAO)
When connection is fi nished, adjust the status, sizes, and volume balance of the
speakers to provide an optimal sound fi eld. This unit is equipped with a YPAO
(Yamaha Parametric Room Acoustic Optimizer) function that adjusts the speaker
balance automatically with a simple procedure.
When you use YPAO, a test tone will be output from the speakers for approximately 3 minutes and acoustic measuring will be performed.
When using YPAO, be careful of the following.
•
The test tone is output at high volume. Please refrain from using this function at night when it may be a nuisance to others nearby.
•
Please take care that the test tone does not frighten any small children.
1
Check the following before using YPAO.
This unit
•
The headphones are removed.
Subwoofer
•
The power is turned on.
•
Volume is set to approximately half, and the cross-over frequency (if present) is set to maximum.
2
Place the supplied YPAO microphone at ear height in your listening position.
When positioning the microphone, we recommend that you use equipment that allows you to adjust the height (such as a tripod) as a
microphone stand. When using a tripod, use the tripod screws to fi x the microphone in place.
3
Press RECEIVER A on the remote control to switch this unit on.
CROSSOVER/
HIGH CUT
VOLUME
MIN
MAX
MIN
MAX
Subwoofer examples
YPAO microphone
- 6 -
Continues to
the next page