DirectConnect 23878 사용자 설명서 - 페이지 3
{카테고리_이름} DirectConnect 23878에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DirectConnect 23878 4 페이지. Professional series racks bar rack
페이지 인쇄Step 3: Unpacking Carton 3 of 3 and assemble Top & Base Assembly to rack.
Installing the Top and Base Assemblies, Legs, and Base Cable Plates (as needed) to
rack assembly.
Using six (6) Phillip screws (D) attach the Top Assembly as unpacked from carton
1 of 3 and attach to Rack Assembly as shown in Figure 4.
Using four (4) Phillip screws (D) attach the Base Assembly (4) as unpacked from
carton 1 of 3 and attach to Rack Assembly as shown in Figure 4.
Using a wrench attach two (4) of the Adjustable Locking Feet (A) onto the bottom
as shown in Fig. 5a
Installing the four (4) (as needed) Base Cable Plates (B) to the Rack Assemblies
CAUTION: Do to the height and weights of the Professional Series Racks do not move
and/or stand up by yourself assistance is required. Always use an assistant or me-
chanical lifting equipment to safely lift and position equipment.
Stand up the completed rack assemblies. Using two (2) Phillip screws (D) for each of
the (as needed) Base Cable Plates (B) (fig.5b) attach each to the top side of Base As-
sembly (4) as shown in Figure 5a.
Step 4: Attaching the doors and panels to the Rack Assemblies
Attach the Custom Vented Tempered Glass Door (1), the Vented Back Door (2),
and the left & right Side Panels (3) to the completed rack assemblies as shown in
Figure 6.
Fig. 5b
6
1.0 HARDWARE LIST
Actual parts appearance and quantity may differ from illustration.
ID
Quantity
Description
1
1
Front Assembly
2
1
Back Assembly
3
2
Side Assembly
4
2
Base Assembly
5
4
Keys
ID
Quantity
Description
Adjustable Locking
A
4
Feet
B
4
Base Cable Plates
M5x10mm bolt (rack
C
25
assembly)
Phillips Screw (base
D
25
assembly)
10-32 bolt
E
50
(mounting rails)
F
50
10-32 Washer
G
50
10-32 Nut Clip
3