Calian SatService sat-nms 사용자 설명서 - 페이지 7

{카테고리_이름} Calian SatService sat-nms에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Calian SatService sat-nms 17 페이지. Power sensor

operated through a router, enter the address of the router on the gateway field, otherwise leave this

field blanc. Be sure, that the 'DHCP' mark is unchecked. Finally click to the 'Yes' button to set the

new parameters at the power sensor

Now the IP configuration of the power sensor is completed. You may finally want to test if the power sensor

is reachable now. Start your web browser and type the power sensor's IP address into the URL field of the

browser. The power sensor should reply with it's main page, provided that the power sensor and your

computer are configured for the same subnet.

2.3 Connecting the Power Sensor

The connectors of the power sensor are placed on both sides. One side contains the RF input connector, the

other side the D/C and Data connectors.

RF connectors

The RF input connector is a make N-type connector, mounted at one front panel of the power sensor

enclosure. At the other side, the Ethernet and power supply connectors are mounted. The Ethernet

connector is a standard 10 Base-T / RJ45 connector. Use a standard network cable to connect the power

sensor to an Ethernet hub. If you want to connect your computer and the power sensor directly without

using a hub, you need a crossover cable for this with swapped RX/TX lines.

The power supply connector also contains the fault relay contact. The latter is a floating Photo MOS solid

state circuit. In fault state (level below an adjustable threshold) or while the unit is powered off it is in hi-Z

state (several MOhms). A resistance below 10 Ohms indicates that the function is OK. The diagram below

shows the pin out of this connector (front view).

D/C and data connectors

www.satnms.com

PS-UM-2002 Page 6/16