Yamaha RX-V800 서비스 매뉴얼 - 페이지 20

{카테고리_이름} Yamaha RX-V800에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha RX-V800 46 페이지.

RX-V800/RX-V800RDS/HTR-5280

7. MANUAL TEST

The noise generator with a built-in DSP outputs the test noise through the channels specified by the sub-menu.

The noise frequency for LFE is 35 to 250 Hz. Other than that, the center frequency is 800Hz.

ALL

[Remote control code: 7A-00 (TAPE PLAY)]

Noise is output from all channels.

MAIN R

[Remote control code: 7A-03 (TAPE STOP)]

Noise is output from the MAIN R channel.

LFE

[Remote control code: 7A-09 (CD STOP)]

Noise is output from the SUB WOOFER

channel.

8. RS-232C

RX-V800 does not use this menu.

9. PRESET

This menu is used to reserve and inhibit initialization of the back-up RAM. The signals are processed using EFFECT OFF.

(The L/R signal is output using ANALOG MAIN BYPASS.)

MAIN L

[Remote control code: 7A-01 (TAPE RW)]

Noise is output from the MAIN L channel.

REAR R

[Remote control code: 7A-04 (TAPE PAUSE)]

Noise is output from the REAR R channel.

PRESET INHIBIT (Initialization inhibited) [REMOTE CONTROL CODE: –]

RAM initialization is not executed. Select this sub-menu to protect the values set

by the user.

PRESET RESERVED (Initialization reserved) [REMOTE CONTROL CODE: 7A-

57 (SLEEP)]

Initialization of the back-up RAM is reserved. (Actually, initialization is executed

next time when the power is turned on.) Select this sub-menu to reset when

shipped out of the factory or to reset RAM.

CENTER

[Remote control code: 7A-02 (TAPE FW)]

Noise is output from the CENTER

channel.

REAR L

[Remote control code: 7A-06 (TAPE A/B)]

Noise is output from the REAR L

channel.