Yamaha YHT-393 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Yamaha YHT-393에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha YHT-393 8 페이지. Home cinema speaker package
Yamaha YHT-393에 대해서도 마찬가지입니다: 소유자 매뉴얼 (12 페이지)

페이지 인쇄

Attaching the non-skid pads

Place the satellite speakers on a sturdy, vibration-free surface, such as a well-built stand. Attach the included

non-skid pads to the bottom of the satellite speakers to prevent the speakers from slipping.

Wall mounting the satellite speakers

4-1/8"

(105 mm)

When using speaker brackets to mount the speakers on a wall or celling, it is strongly recommended that

safety wire, which may be included with the bracket, be used between the speaker and the bracket to prevent

the speaker from falling.

Fasten screws into a firm wall or wall support as shown in the figure, and hang the holes of the mounting

bracket on the protruding screws.

Make sure that the screws are securely caught by the narrow sections of the "key hole" opening.

WARNING

Each speaker weighs 1.6 lbs (0.7 kg). Do not mount the speakers on thin plywood or a wall with soft surface

material, since the screws may pull away from the surface and fall. This will damage the speakers and can

cause personal injury.

Do not mount the speakers on a wall with nails, adhesives, or any other unstable hardware. Long-term use

and vibrations may cause them to fall.

To avoid accidents resulting from tripping over loose speaker cords, they should be affixed to the wall or floor

molding.

Secure installation is the purchaser's responsibility.

NS-AP2600

SETTING UP THE SPEAKERS

You can also use the screw

holes on the back of the

speaker for installing the

speakers on commercially

available speaker brackets.

2-3/8"

(60 mm)

A screw with a diameter of

1/4" can be used.

(Hole depth: 9/32")

Non-skid pads

Wall / wall support

3/8"

Tapping screw

(Available at

the hardware store)

Min