Yamaha A-S2000 - Amplifier 소유자 매뉴얼 - 페이지 17

{카테고리_이름} Yamaha A-S2000 - Amplifier에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha A-S2000 - Amplifier 34 페이지.
Yamaha A-S2000 - Amplifier에 대해서도 마찬가지입니다: 소유자 매뉴얼 (43 페이지), 소유자 매뉴얼 (35 페이지)

페이지 인쇄

Bi-wire connection

The bi-wire connection separates the woofer from the

combined midrange and tweeter section. A bi-wire

compatible speaker has four binding post terminals. These

two sets of terminals allow the speaker to be split into two

independent sections. This split connects the mid and high

frequency drivers to one set of terminals and the low

frequency driver to the other pair.

Caution

To use the bi-wire connections, the impedance of each speaker

must be 8 Ω or higher.

Notes

• Remove the shorting bars or bridges to separate the LPF (low

pass filter) and HPF (high pass filter) crossovers.

• To use the bi-wire connections, switch the SPEAKERS selector

to the A+B BI-WIRING position.

Connecting to the CD BAL jacks

Connect your CD player with the XLR balanced output

jacks. The pin assignments for these jacks are shown

below. Refer to the owner's manual supplied with your

CD player and verify that its XLR balanced output jacks

are compatible with the pin assignments.

2: hot

3: cold

When connecting, be sure to match the pins and insert the

connector of the "male" XLR balanced cable until you

hear a "click". When disconnecting, pull out the "male"

XLR balanced cable while holding down the lever of the

CD BAL jacks.

"Female" XLR connector

"Male" XLR connector

Note

To use the XLR balanced connection, you must switch the

INPUT selector on the front panel to the CD BAL position.

1: ground