Yamaha A-S501 소유자 매뉴얼 - 페이지 14

{카테고리_이름} Yamaha A-S501에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha A-S501 40 페이지. Integrated amplifier
Yamaha A-S501에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지), 소유자 매뉴얼 (39 페이지), 소유자 매뉴얼 (35 페이지)

페이지 인쇄

CONNECTIONS

■ REC jacks

• The audio signals are not output via the LINE 2 REC

or LINE 3 REC output jacks when LINE 2 or LINE 3

is selected with the INPUT selector.

• The VOLUME, BASS, TREBLE, BALANCE and

LOUDNESS controls and the CD DIRECT function

(or the PURE DIRECT function) have no effect on the

source being recorded.

■ Connecting speaker cables

1 Remove approximately 10 mm (3/8 in) of insulation

from the end of each speaker cable.

2 Twist the bare wires of the cable firmly together.

3 Unscrew the knob.

4 Insert one bare wire into the hole in the side of each

terminal.

5 Tighten the knob to secure the wire.

Red: positive (+)

Black: negative (–)

CAUTION

• Set the IMPEDANCE SELECTOR switch according to

the impedance of the speakers to be connected (see

page 5).

• Do not let bare speaker wires touch each other or any

metal part of this unit. This could damage this unit and/

or the speakers.

■ Connecting via banana plug

(North America, General, China and

Australia models only)

1 Tighten the knob.

2 Insert the banana plug into the end of the

corresponding terminal.

Banana plug

■ Bi-wire connection

In the case of speakers supporting the bi-wiring

connection, the tweeter/midrange unit and woofer of the

speakers can be driven independently through connections

shown in the following figure, allowing you to enjoy clear

mid- and high-range sounds.

Connect the other speaker to the other set of terminals in

the same way.

Note

When making bi-wire connections, remove the shorting bridges

or cables on the speaker. Refer to the speakers' instruction

manuals for more information.

To use the bi-wire connections, set the SPEAKERS selector on

the front panel to the A+B BI-WIRING position.

10 mm (3/8 in)

Connecting power cable

CAUTION

(General model only)

Before connecting the power cable, make sure you set

VOLTAGE SELECTOR of this unit according to your

local voltage. Improper setting of VOLTAGE SELECTOR

may cause fire and damage to this unit.

■ AC IN (A-S701)

Connect the supplied power cable to AC IN after all other

connections are complete.

■ Power cable (A-S501, A-S301)

Connect the power cable to an AC wall outlet after all

other connections are complete.

Rear panel

Speaker

To the AC

wall outlet

(A-S501, A-S301)

To the AC

wall outlet

(A-S701)