Yamaha AG-Stomp 소유자 매뉴얼 - 페이지 13

{카테고리_이름} Yamaha AG-Stomp에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha AG-Stomp 32 페이지. Yamaha accoustic guitar/pre-amplifier owner's manual
Yamaha AG-Stomp에 대해서도 마찬가지입니다: 서비스 매뉴얼 (45 페이지), 패치 목록 (1 페이지), (네덜란드어) 매뉴얼 (32 페이지)

페이지 인쇄

I Produce Sound

1. After confirming that the OUTPUT knob is set to

"0", press the Power Switch (STAND-BY) ON

(

Switching the Power Switch ON when the OUTPUT

knob is turned up may result in damage to devices

such as the amplifier, speaker, headphones, etc.,

or cause unexpected accidents like damage to

your hearing due to high volume settings.

U01

2. "

" will appear in the display.

The characters (Memory Area: U (user), Bank

Number: 0, Patch Number:1) indicate the cur-

rently selected patch.

When a patch number is shown in the display,

this condition is known as the Play Mode. When

in the Play Mode, patches can be selected and

the knobs and buttons can be used to edit set-

tings.

For now, try using this patch to produce some

sound.

3. Play a chord on the guitar and rotate the OUT-

PUT knob to the right to adjust the volume.

* If clipping due to the input signal overloading the AG-Stomp's

circuit occurs, the BANK Switch Lamp will light.

If this is the case, reduce the volume on the guitar, or adjust

the AG-Stomp's VOLUME, individual TONE control knobs

or individual Effect knobs. Also, if feedback occurs, please

refer to the "Feedback Reduction" section on page 16.

Using the AG-Stomp

I Editing Settings

The panel knob and button functions can be used

to create your own original tone.

G Changing Pre-amp Settings

Since the AG-Stomp's knob positions do not always

represent the tone that is currently being produced,

the knob must be "aligned" with the value set in

memory before changes can be made to that value.

For this reason, please follow the rules described

below when rotating the knobs.

• If the [UP] lamp flashes when a knob is rotated,

rotate the knob to the right (toward 10). If the

[DOWN] lamp flashes, rotate the knob to the left

(toward 0).

At this time, the patch's data value (the value set

in the patch for the knob you are turning) will

flash in the display.

* As long as the value is flashing in the display, the display

and tone will not change even though the knob is being

rotated.

• Continue rotating the knob, when the knob

reaches the position corresponding to the patch's

data value, the display as well as the [UP]/

[DOWN] lamps will stop flashing. After this, the

tone will change according to the knob's posi-

tion.

* After you stop moving the knob, the value will be displayed

for approximately two more seconds, then return to the nor-

mal display.

* Even if only one value is changed, the [MANUAL] lamp

will flash to indicate that data in the patch has been

changed.

Also, when all settings (except for the OUTPUT knob) are

changed, the [MANUAL] lamp will light.

• Once the knob is in an editable condition (in

which the patch data's value can be changed),

rotating the knob will result in the value shown in

the display changing in regards to the knob's

position causing a relative change in tone.