Yamaha AG-Stomp 소유자 매뉴얼 - 페이지 20

{카테고리_이름} Yamaha AG-Stomp에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha AG-Stomp 32 페이지. Yamaha accoustic guitar/pre-amplifier owner's manual
Yamaha AG-Stomp에 대해서도 마찬가지입니다: 서비스 매뉴얼 (45 페이지), 패치 목록 (1 페이지), (네덜란드어) 매뉴얼 (32 페이지)

페이지 인쇄

Using the AG-Stomp

G Using the AG-Stomp Without Patches

The [MANUAL] button gives you direct control of the

AG-Stomp's parameters and effects when patches

are not used.

Press the [MANUAL] button to enter the Manual

Mode (the lamp will light). In this mode, the tone

produced by the AG-Stomp is determined by the

current position of all knobs and effect buttons (with

the exception of the [FEEDBACK REDUCTION]

buttons), changes to any knob or button will have a

direct effect on the tone.

To exit the Manual Mode, simply recall any patch.

Press a Footswitch (1-3) that corresponds to the

patch number shown in the display to return the AG-

Stomp to the same condition previous to entering

the Manual Mode.

Also, the MANUAL Mode will be exited if the [SHIFT]

button is pressed to enter the SHIFT mode for edit-

ing one of the secondary parameters. At this time

the [MANUAL] button's lamp will flash.

G Using a Foot Pedal (Controller)

A foot controller (expression pedal) (optional) such

as the YAMAHA FC-7, etc. connected to the EXP.

PEDAL jacks can be used to control of the AG-

Stomp's volume, tone or effect parameters (setting

values).

→ page 22 [External Control Settings]

G Control the AG-Stomp From an Exter-

nal MIDI Device

An external MIDI device's MIDI OUT jack, connected

to the AG-Stomp's MIDI IN jack via a MIDI cable

can be used to control the AG-Stomp's volume, tone

or effect parameters (setting values).

→ page 22 [External Control Settings]

G Chromatic Auto Tuner Function

To enter the Tuner Mode, press the [UTILITY] and

[STORE] buttons simultaneously, or hold the BANK

switch until "

" appears in the display when in the

Play Mode. The Tuner Mode supplies you with a

chromatic auto tuner for tuning.

→ page 23 [Tuner Mode]

G Factory Default

To return the AG-Stomp's settings to their factory

default condition, simultaneously hold the [UP] and

[MANUAL] buttons and turn the Power ON (

data in the USER AREA will be rewritten with data

for the patches listed in the "Patch List" which can

be found on a supplemental sheet.

When the AG-Stomp is reset to its factory

default condition, all patch data you stored

will be erased. We recommend that any

important data be stored in an external

MIDI device or that notes be taken of the

settings.

), all