Yamaha AP-U70 설정 매뉴얼 - 페이지 33
{카테고리_이름} Yamaha AP-U70에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha AP-U70 47 페이지. Personal amplifier
Yamaha AP-U70에 대해서도 마찬가지입니다: 서비스 매뉴얼 (46 페이지)
BASIC OPERATION
BASIC OPERATION
Playing a source
This section explains how to turn on this unit and select
input sources. If any external audio equipment is
connected to this unit, turn it on first.
USB
PC
AUX1
AUX2
VIRTUAL
5.I
CH
DIGITAL
USB PCM
D. DSP
PROLOGIC FM AM ST
VOL
DSP
M U T E
1
Turn on this unit.
Front panel
The message "Hello" appears for a few seconds, and this
unit returns to the state in which it was last used (e.g., the
input source that was selected when this unit was turned off
is selected).
2
Decrease the volume to minimum (MIN).
Front panel
3
Select an input source by using the input selector
keys.
The corresponding indicator on the front panel lights up.
USB
PC
AUX1
AUX2
Front panel
Refer to the explanation on the right side for details about
using the input selector keys.
8
E-
1
POWER
USB
3
PC
3
AUX1
AUX2
HALL
JAZZ
CHURCH
GAME
MOVIE
LIVE
VDD
TEST
ON/OFF
A
B
C
5
MUTE
VOLUME
2, 5
1
POWER
or
Remote control
VOLUME
or
Remote control
USB
PC
or
AUX1
AUX2
Remote control
4
Start the selected input source.
5
Adjust the volume to the desired level.
Front panel
6
As you prefer, use a sound field program.
Refer to page 10 for details about the sound field programs.
About the input selector keys
Each of the input selector keys selects the following input signals.
USB:
Press the USB key to select
input signals at the USB
terminal.
PC:
Press the PC key repeatedly to select the PC inputs:
"PC_DIGT" and "PC_ANLG". PC_DIGT selects the
DIGITAL PC COAX IN or DIGITAL PC OPT IN, and
PC_ANLG selects the ANALOG PC IN.
Note: The DIGITAL PC OPT IN has priority over the
DIGITAL PC COAX IN, so if you connect to both inputs,
the signal received at the DIGITAL PC OPT IN is used.
VOL
AUX1:
Press the AUX1 key repeatedly to select the inputs:
"AUX1_DG" and "AUX1_AN". AUX1_DG selects the
equipment connected to the DIGITAL AUX 1 OPT IN, and
AUX1_AN selects the equipment connected to the
ANALOG AUX 1 IN connector as the input source.
VOL
AUX2:
Press the AUX2 key to select
the equipment connected to
the ANALOG AUX 2 IN
connectors as the input
source.
VOLUME
or
Remote control
VOL
VOL
VOL
VOL