Yamaha AX-892 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Yamaha AX-892에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha AX-892 24 페이지. Natural sound stereo amplifier

페이지 인쇄

CONNECTING SPEAKERS

Connect the SPEAKERS terminals to your speakers with cable

of the proper gauge, cut as short as possible. If the speakers

are improperly connected, no sound will be heard. Connect

each speaker making sure that the polarity (+ and –) is correct.

Red: positive (+)

Black: negative (–)

If the cables are reversed, the sound will be unnatural and will

lack bass. Do not allow exposed wires to touch each other

or metal parts; this could damage the unit and speakers.

For AX-492's SPEAKERS A and B terminals and

for AX-592's SPEAKERS B terminals only:

Unscrew the knob.

Insert the exposed wire.

[Remove approx. 5 mm

(1/4 in) insulation from

the speaker wires.]

Tighten the knob and

secure the wire.

Banana plug connections are also possible. Simply insert the

banana plug connector into the corresponding terminal.

(except for UK and Europe models)

REAR PANEL PARTS

AC OUTLETS (SWITCHED)

Use these to connect the power cords from your components

to this unit.

The power to the SWITCHED outlets is controlled by this unit's

POWER switch or the remote control's POWER key. These

outlets will supply power to the connected components

whenever this unit is turned on.

One or two speaker systems can be connected to this unit.

If you connect only one speaker system, connect it to either

SPEAKERS A or B terminals.

Use speakers with the specified impedance shown on the

rear panel.

For AX-592's SPEAKERS A terminals only and

for AX-892's SPEAKERS A and B terminals:

Unscrew the knob.

Insert the exposed wire.

[Remove approx. 5 mm (1/4

in) insulation from the

speaker wires.]

Tighten the knob and secure

the wire.

The maximum power (total power consumption of

components) that can be connected to the AC OUTLETS

(SWITCHED) is 100 watts.

9 9