Yamaha BBT500-115 소유자 매뉴얼 - 페이지 13

{카테고리_이름} Yamaha BBT500-115에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha BBT500-115 21 페이지. Preset patch list
Yamaha BBT500-115에 대해서도 마찬가지입니다: 보충 설명서 (1 페이지)

페이지 인쇄

1. Panel Controls and Connections

Detailed Parameter Settings

The BBT500 also features more precise settings for defining the fre-

quencies for each of the Tone Control knobs, operating the Compressor

and Noise Gate, or setting the Blend Level of the effect loop, etc.

To access these settings, press the [FUNCTION] switch and use the

four Modes described below.

• Amp Mode

In this mode, each knob functions in the manner it is labeled on the

front panel.

• Equalizer Mode

This mode is used to set the 1-band parametric equalizer and the

center frequency for each of the Tone Controls (Bass – Treble).

• Compressor Mode

This mode is used to set the Compressor's blend level, noise gate

level, and effect loop.

• Utility Mode

This mode is used to set the crossover filter, and individual MIDI

settings.

Individual settings in the Amp Mode, Equalizer Mode, and Compressor

Mode are saved when patch data is saved to the unit's memory.

Individual parameter settings in the Equalizer Mode and Compressor

Mode are set to their default values when the power is switched ON.

Individual settings in the Utility Mode are saved when exiting the Utility

Mode, and they are retained even if the power is switched OFF.

Amp Mode

Each knob functions in the manner it is labeled on the panel.

In the Amp Mode, the knob's value (or patch's setting value) is shown

on the display when the knob is turned.

* After the BBT500's power is switched ON or the [MANUAL] switch is

pressed, nothing is shown in the display until a Memory is recalled, or a

mode other than the Amp Mode is selected.

Enter the Amp Mode using one of the following methods.

• The Amp Mode is the default mode when the BBT500's power is

switched ON.

• Press the [MANUAL] Switch to enter the Amp Mode.

• Press a Memory Switch [1] – [5] to recall a patch. Or, press and

hold a Memory Switch to save a patch to memory.

• In the Equalizer, Compressor, or Utility Mode, press the [FUNC-

TION] switch.

● How Knobs Function in the Amp Mode

The knob's value is shown on the display

when the knob is turned.

e r t y u i o !0 !1

Each control knob's function in the Amp Mode is the same as de-

scribed in the "Sound Setting" section (→ pg. 11).

INPUT LEVEL: Sets the Input Level

SOUND TYPE: Selects the Sound Type (11 types)

COMP: Compression Ratio (1.0 to ∞, 16 steps)

GAIN: Pre-Amp Gain (0 to 10, 0.1 step)

MASTER: Master Volume (0 to 10, 0.1 step)

BASS: Bass Frequency (-15dB to +15dB, 0.2dB step)

LOW MID: Low Mid Frequency (-15dB to +15dB, 0.2dB step)

MIDDLE: Middle Frequency (-15dB to +15dB, 0.2dB step)

HIGH MID: High mid Frequency (-15dB to +15dB, 0.2dB step)

TREBLE: Treble Frequency (-15dB to +15dB, 0.2dB step)

OUTPUT: Sets the output level