Yamaha BBT500-115 소유자 매뉴얼 - 페이지 18

{카테고리_이름} Yamaha BBT500-115에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha BBT500-115 21 페이지. Preset patch list
Yamaha BBT500-115에 대해서도 마찬가지입니다: 보충 설명서 (1 페이지)

페이지 인쇄
Yamaha BBT500-115 소유자 매뉴얼

Air Flow

The device utilizes a forced air cooling system, which cools the interior of the unit by drawing air through the front intake by the fan, which
push the air out the back.

Error Messages

If an error occurs during operation, one of the following error message numbers will appear on the display.
E1
MIDI Receive Buffer Full
:
CAUSE:
SOLUTION:
E2
Communication Error.
:
CAUSE:
SOLUTION:
E3
Bulk Receive Check Sum Error.
:
CAUSE:
SOLUTION:
E4
MIDI Receive Data Abnormality.
:
CAUSE:
SOLUTION:

Troubleshooting

• No Sound
→ Is the power cord properly connected to the device?
→ Is the volume turned up on the instrument connected to the INPUT jack?
→ Are the INPUT LEVEL, GAIN, MASTER, OUTPUT control knobs set to "0"?
→ Check the Effect Loop's BLEND setting (Compressor Mode: TREBLE control knob). Unless an external effector is connected
to the device, raising the BLEND control will result in lowering the original sound. If the BLEND control is set to "100", the
original sound will not be produced.
• Sound output is low
→ Is the volume turned up on the instrument connected to the INPUT jack?
→ Are the INPUT LEVEL, GAIN, MASTER, OUTPUT control knobs turned up?
→ Check the Effect Loop's BLEND setting (Compressor Mode: TREBLE control knob). Unless an external effector is connected
to the device, raising the BLEND control will result in lowering the original sound. If the BLEND control is set to "100", the
original sound will not be produced.
→ Check the Compressor setting. A low Threshold setting or a high Ratio setting will result in a lowered the output signal level.
Also, a long release setting or low Compressor Gain setting will result in a lowered output signal level.
18
Front view
Intake
Too much MIDI data is being received by the BBT500 at one time.
Try reducing the amount of data being sent or, break the data into smaller blocks.
An abnormality is detected during MIDI communications.
Check all connections, etc. and try again.
The check sum does not match the received MIDI bulk data.
Check all connections and data, and try again.
An abnormality is detected in the received MIDI data.
Check all connections and data, and try again.
Rear view
Cooling fan
Exhaust