Yamaha CP2000 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Yamaha CP2000에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha CP2000 20 페이지. Yamaha power amplifier owner's manual
Yamaha CP2000에 대해서도 마찬가지입니다: 서비스 매뉴얼 (33 페이지), 서비스 매뉴얼 (33 페이지)

페이지 인쇄

1. Specifications

Rear Panel

INPUT

CHANNEL R

CHANNEL L

STEREO

BRIDGE

NEUTRIK

PARALLEL

OFF

YAMAHA

SPEAKER PROCESSING

2 3

INPUTs

The inputs for each CP2000 channel comprise of one 1/4" phone jack and one

XLR-3-31-type connector. Both connectors are electronically balanced, although they

can also be used with unbalanced sources. See "Connecting Inputs" on page 7 for more

information. See also "Hookup Examples" on page 4.

Since the phone jack and XLR-type connector on each channel are internally con-

nected, either connector can be used to distribute the input signal to another ampliﬁer.

See "Daisy Chaining Inputs" on page 12 for more information.

Mode switch

This switch is used to select the ampliﬁer's mode of operation: STEREO, PARALLEL,

or BRIDGE.

STEREO —In this mode, which is typically used to amplify stereo sources, the L and R

channels operate independently.

PARALLEL —In this mode, the L and R channels operate independently but the input

signal for both channels is sourced from the Channel L inputs. This mode is typically

used with a mono source and allows independent volume control of two sets of speak-

ers.

BRIDGE —In this mode, the L and R channels are combined to form a massive 2000

watt single-channel ampliﬁer. The input signal is sourced from the Channel L inputs,

the volume level is set by using the Channel L LEVEL control, and the speakers are con-

nected to the binding posts labelled BRIDGE.

YAMAHA SPEAKER PROCESSING switch

This switch is used to activate the special EQ processing that optimizes the CP2000 for

use with the Yamaha S115 and S112 loudspeakers. When other speakers are used, this

switch should be set to OFF. See "Connecting S115 and S112 loudspeakers" on page 11

for more information.

SPEAKERS connectors

The outputs for each CP2000 channel comprise of one 1/4" phone jack and one pair of

5-way binding posts. The 1/4" phone jacks accept 1/4" phone plugs, while the 5-way

binding posts offer several methods of connection, including single or double banana

plugs, spade lugs, or bare wires. See "Connecting Speakers" on page 9 for more infor-

mation. See also "Hookup Examples" on page 4.

(BRIDGE)

Rear Panel

(–)

BRIDGE

(+)

CHANNEL R

CHANNEL L

SPEAKERS

CP2000—Owner's Manual