Yamaha CX-A5200 소유자 매뉴얼 - 페이지 14

{카테고리_이름} Yamaha CX-A5200에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha CX-A5200 28 페이지. Av
Yamaha CX-A5200에 대해서도 마찬가지입니다: 연결 예시 (2 페이지)

Connecting speakers

■ Note on the speaker impedance

The unit supports the following speaker impedance.

• CH.3 A/B: 4  or more (8  or more when using CH.3 A and CH.3 B at the same time)

• BRIDGE connection: 8  or more

• Other channels: 6  or more

Set the IMPEDANCE SELECTOR to the upper/lower position depending on the speakers

connected to the unit.

Select this option when your speaker system meets one of the followings.

• When connecting speakers with impedance of less than 8  (4  or more) to the CH.3

A or CH.3 B terminal

• When using two pairs of speakers connected to the CH.3 A/B terminals at the same

time (be sure to use 8-ohm speakers for both CH.3 A and CH.3 B)

Upper position

• When simultaneously using speakers of 8 Ω or more connected to both CH.3 A

terminals and CH.4 terminals.

• When connecting speakers with impedance of less than 8  (6  or more) to speaker

terminals other than CH.3 A or CH.3 B

Lower position

Select this option when using speakers with impedance of 8

(default)

■ Connecting speaker cables

Speaker cables have two wires. One is for connecting the negative (-) terminal of the unit and the

speaker, and the other is for the positive (+) terminal. If the wires are colored to prevent confusion,

connect the black wire to the negative and the other wire to the positive terminal.

a Remove approximately 10 mm (0.40 in) of insulation from the ends of the speaker cable, and

twist the bare wires of the cable firmly together.

b Loosen the speaker terminal.

c Insert the bare wires of the cable into the gap on the side (upper left or bottom right) of the

terminal.

d Tighten the terminal.

c c

a a

Using a banana plug

(U.S.A., Canada, China, Taiwan and Australia models only)

a Tighten the speaker terminal.

b Insert a banana plug into the end of the terminal.

b b

a a



or more only.

d d

b b

Banana plug

Connections