Yamaha DG100-212 서비스 매뉴얼 - 페이지 21
{카테고리_이름} Yamaha DG100-212에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha DG100-212 42 페이지. Yamaha guitar amplifier owner's manual
Yamaha DG100-212에 대해서도 마찬가지입니다: 소유자 매뉴얼 (32 페이지)
페이지 인쇄
ERROR MESSAGES
If an error occurs during operation, one of the following error message numbers will appear on the display.
: Motor Drive Error
CAUSE:
The volume knob has not returned to its assigned position after 20 seconds has elapsed from the start of the recall
operation or, the device does not recognize the recall command.
SOLUTION:
Turn off the power and check the circuit for Motor Drive.
: MIDI Receive Buffer Full
CAUSE:
Too much MIDI data is being received by the DG100-212 at one time.
SOLUTION:
Try reducing the amount of data being sent or, break the data into smaller blocks.
: Communication Error.
CAUSE:
An abnormality is detected during MIDI communications.
SOLUTION:
Check all connections, etc. and try again.
: Bulk Receive Check Sum Error.
CAUSE:
The check sum does not match the received MIDI bulk data.
SOLUTION:
Check all connections and data, and try again.
: Bulk Receive Data Abnormality.
CAUSE:
An abnormality is detected in the received MIDI bulk data.
SOLUTION:
Check all connections and data, and try again.
: Backup Battery Error.
CAUSE:
Backup battery power is depleted.
SOLUTION:
Continued use of the device will result in the loss of data. Return the device to the music dealer where you purchased it
or, the nearest Yamaha Service center and have the battery replaced.
DG100-212
21