Yamaha DSP-A590 소유자 매뉴얼 - 페이지 15
{카테고리_이름} Yamaha DSP-A590에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha DSP-A590 27 페이지. Natural sound digital sound field processing amplifier
페이지 인쇄
TO PLAY A SOURCE
1
Set to the "
2
3
Select the desired input source by using the input
selector buttons.
(For video sources, turn the TV/monitor ON.)
TAPE
MONITOR
TUNER
VIDEO AUX
VCR 2
* The name of the selected input source will appear in
the display.
4
Select the front speakers to be used.
SPEAKERS
A
ON
OFF
* If you use two front speaker systems, press both the A and
B switches.
BASIC OPERATIONS
2
4
∞
" position.
POWER
CD
PHONO
VCR 1
LD/TV
B
ON
OFF
7
3
7
5
Play the source.
6
Adjust to the desired output level.
7
If desired, adjust the BASS, TREBLE, BALANCE
controls, etc. (refer to page 17) and use the digital
sound field processor. (Refer to page 20.)
Notes on using the input selector buttons
Note that pressing on each input selector button selects
the source which is connected to the corresponding input
terminals on the rear panel.
* To select the source connected to the VIDEO AUX
terminals on the front panel, press VIDEO AUX.
The selection of TAPE MONITOR cannot be canceled by
pressing another input selector button. To cancel it, press
TAPE MONITOR again.
When you select a button other than TAPE MONITOR,
make sure that TAPE MONITOR is not also selected.
If you select the input selector button for a video source
without canceling the selection of TAPE MONITOR, the
playback result will be the video image from the video
source and the sound from the audio tape.
Once you play a video source, its video image will not be
interrupted even if the input selector button for an audio
source is selected.
To turn off the power
Press the POWER switch again.
1, 6
15