Yamaha Electone C-40 사용자 설명서 - 페이지 7

{카테고리_이름} Yamaha Electone C-40에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha Electone C-40 11 페이지. Natural sound stereo control amplifier
Yamaha Electone C-40에 대해서도 마찬가지입니다: 소유자 매뉴얼 (12 페이지), 소유자 매뉴얼 (2 페이지), 매뉴얼 (32 페이지), 소유자 매뉴얼 (12 페이지), 매뉴얼 (32 페이지)

페이지 인쇄

Action and Intonation, cont'd

Step 2:

Put the ball end of the string in the hole.

Push the pin in the hole, all the way down, with

the groove in the pin facing the soundhole (look

at the other pins to see how far to push in). With

your finger holding the pin down, pull up on the

string. This ensures that the ball of the string is

pulled up tightly against the inside of the top

of the guitar. If this hasn't been secured, the

pin will lift up and pop out as you tighten the

string and you'll have to start again.

Step 3:

Pass the other end of the string through

the appropriate tuning peg. Leave enough slack

on the string so that it can be wrapped two or

three times around the tuning peg.

Step 4:

Tighten the string, either by hand or

with a peg winder. You will need one hand to

hold the string tight as you do this (to keep the

windings in place as it wraps around the tuning

peg). Do not let go or you will get a very curly

string that will need to be wound again!

Step 5:

Once you have tuned the string to

the proper tension, cut off the excess string

with the wire cutters.