Yamaha KAX-2500 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Yamaha KAX-2500에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha KAX-2500 16 페이지. Owner's manual

■ Wiring

(1) Turn off the POWER switch.

(2) Remove the cover attachment screws and remove the pro-

tective cover from the speaker terminals.

(3) Remove about 15 mm of insulation from the end of each

speaker cable, and pass the bare wire through the holes in

the appropriate speaker terminals. Tighten the terminals to

securely clamp the wires. Refer to page 9 for speaker

polarities.

Speaker cable

Be sure that the bare wire ends do not jut out from the ter-

minals and touch the chassis. The following shows how the

cable should look when correctly attached.

(4) Reattach the protective cover over the speaker terminals.

Screw

* Actual size

Bare wire

Chassis

Speakon connector

(1) Turn off the POWER switch.

(2) Insert the Neutrik NL4FC plugs into the Speakon connec-

tor on the rear of the amplifier, and turn clockwise to lock.

Neutrik NL4FC plugs

CHANNEL

STEREO or PARALLEL

1–

2–

Neutrik NL4FC plugs

CHANNEL

1–

Phone jack

(1) Turn off the POWER switch.

(2) Insert the phone plug into the jack on the rear of the ampli-

fier.

BRIDGE

A+

A–

1–

B+

–

B–

2–

B+

B–