Yamaha TX6n 소유자 매뉴얼 - 페이지 10
{카테고리_이름} Yamaha TX6n에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha TX6n 24 페이지. Txn series
Yamaha TX6n에 대해서도 마찬가지입니다: 사양 (4 페이지), 소유자 매뉴얼 (24 페이지), 소유자 매뉴얼 (24 페이지), 소유자 매뉴얼 (24 페이지), 소유자 매뉴얼 (24 페이지)
페이지 인쇄
Basic Operation of the TXn
Operations that can be Performed from the Panel
• For details, refer to the TX6n/5n/4n Reference Manual.
NOTE
Category
METER
ANA INPUT VOLTAGE
SLOT INPUT VOLTAGE
SP OUTPUT VOLTAGE
SP OUTPUT POWER
SP OUTPUT IMPEDANCE
SLOT OUTPUT METER
THERMAL
UTILITY
Device Setup
Word Clock Setup
Information
Network Setup
LCD Setup
Front Panel Operation
Scene Setup
Misc Setup
MENU
General
Signal Path
Signal Chain
Calibration
Limiter
SCENE
Recall
Store
Edit
Clear
*Scene..........The settings listed above, such as power Standby/On or mute (with the exception of UTILITY), are called a "scene". By recalling a scene, the
saved settings can be immediately applied to the amplifiers.
10
TX6n/5n/4n Owner's Manual
Subcategory
Shows the input level from the analog input connectors.
Shows the input level from the slot.
Shows the output level from the [SPEAKERS] connectors.
Shows the output power from the [SPEAKERS] connectors.
Shows the output impedance from the [SPEAKERS] connectors.
Shows the output level to the slot.
Shows the heat sink temperature.
Makes settings to distinguish the amplifier on a network.
Sets the word clock.
Shows information about the amplifier.
Specifies the IP address and other settings for using the amplifier in a net-
work.
Specifies the display settings.
Turns panel operation lock on/off.
Makes scene* settings.
Sets the amplifier's internal clock, etc.
Sensitivity/Amp Gain
Sets the input sensitivity/gain.
Stereo/Bridge/Parallel
Specifies the amplifier's mode (Stereo/Bridge/Parallel).
Attenation Link
Specifies whether attenuator operation will be linked between channels A
and B.
Input Redundancy
Specifies the redundant connection mode, etc.
Makes settings for the equalizer, delay, crossover, and others that process
the audio signal. Speaker Processor libraries can also be recalled.
Analog Input Signal Chain
Makes settings for checking whether the audio signal is being correctly
input from the analog connectors.
Slot Input Signal Chain
Makes settings for checking whether the audio signal is being correctly
input from the slot.
Output Signal Chain
Makes settings for checking the status of output from the [SPEAKERS]
connectors.
Calibrate by Pilot Tone
Uses a pilot tone to measure the impedance of the connected speakers.
Calibrate by Program
Uses an audio signal to measure the impedance of the connected speak-
Source
ers.
Voltage Limiter
Makes settings for the limiter.
Power Limiter
Limiter Gain Reduction
Specifies whether the limiter will be linked between channels A and B.
Recalls a scene*.
Stores a scene*.
Edits a scene*.
Clears a scene*.
Explanation