Yamaha XMV4280 소유자 매뉴얼 - 페이지 22

{카테고리_이름} Yamaha XMV4280에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha XMV4280 42 페이지. Power amplifier
Yamaha XMV4280에 대해서도 마찬가지입니다: 소유자 매뉴얼 (38 페이지), 소유자 매뉴얼 (43 페이지), 소유자 매뉴얼 (39 페이지)

페이지 인쇄

Connections and Setting Up



Connecting the [REMOTE] Connector or

[FAULT OUTPUT] Connector

You must use the supplied Euroblock plugs when making con-

nections to the [REMOTE] connector or [FAULT OUTPUT]

connector.

If these have been lost, please contact your Yamaha dealer.

Cable preparation

approx.

5 mm

• To prepare the cable for attachment to a Euroblock

connector, strip the wire as shown in the illustration

using stranded wire to make connections. With a Euro-

block connection, stranded wires may be prone to

breakage because of metal fatigue due to the weight of

the cable or due to vibration.

NOTE

Do not tin (plate with solder) the exposed end.

• If cables will be frequently connected and discon-

nected, as in the case of a portable installation, we

recommend that you use ferrules with insulation

sleeves. Use a ferrule whose conductor portion has an

external diameter of 1.3 mm or less, and a length of

approximately 5 mm (such as the AI0,5-6WH made by

the Phoenix Contact corporation).

1.3 mm or less

1. Loosen terminal screws.

Loosen.

Terminal

screw

NOTE

A slotted screwdriver with a blade width of about 3 millime-

ters is recommended.

3 mm or less

XMV4280/XMV4140/XMV4280-D/XMV4140-D Owner's Manual

approx.

5 mm

Slotted screwdriver

Euroblock plug

2. Insert cables.

3. Securely tighten terminal screws.

Pull the cables (not too strongly) to confirm that they are

securely connected.

4. Insert the Euroblock plug into the [REMOTE]

connector or [FAULT OUTPUT] connector of

the device.