Yamaha XMV4280-D 소유자 매뉴얼 - 페이지 21

{카테고리_이름} Yamaha XMV4280-D에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha XMV4280-D 42 페이지. Power amplifier
Yamaha XMV4280-D에 대해서도 마찬가지입니다: 소유자 매뉴얼 (43 페이지)

페이지 인쇄

[REMOTE] and [FAULT OUTPUT] Con-

nectors

This chapter explains how to use and connect the [REMOTE]

connector and [FAULT OUTPUT] connector located on the rear

panel of the XMV.



Using the [REMOTE] Connector

(Euroblock 3-pin)

You can connect switches to the rear panel [REMOTE] connec-

tor (page 15), and use them to remotely mute/unmute all chan-

nels or switch the power standby/on status.

From the left, the [REMOTE] connector consists of MUTE

ALL, STANDBY, and GND pins.

The [REMOTE] connector uses a Euroblock plug.

For details on how to connect Euroblock plugs, refer to "Con-

necting the [REMOTE] Connector or [FAULT OUTPUT] Con-

nector" (page 22).

• Muting/unmuting all channels

Turning mute on

NOTE

When all channels are muted via the [REMOTE] connector,

the [MUTE] button on the front panel cannot be operated.

• Switching the power standby/on status

Switching the power to

standby

NOTE

When the power is set to standby via the [REMOTE] con-

nector, turning on the power switch will place the unit in

standby mode.

Turning mute off

Turning the power on



Using the [FAULT OUTPUT] Connector

(Euroblock 3-pin)

A lamp or other indicator can be connected to the rear panel

[FAULT OUTPUT] connector to inform an operator when a

problem occurs.

The [FAULT OUTPUT] connector (page 15) consists of NO

(Normally Open), C (Common), and NC (Normally Closed)

pins. The [FAULT OUTPUT] connector is a relay circuit that

operates as follows.

Normal state

Fault condition

Open

Closed

The [FAULT OUTPUT] connector uses a Euroblock plug. For

details on how to connect Euroblock plugs, refer to "Connecting

the [REMOTE] Connector or [FAULT OUTPUT] Connector"

(page 22).

Example: Using an LED to indicate the

XMV's normal/fault status



Normal state

XMV



Shut-down state

XMV

CAUTION

The rated load of the relay contacts is 1A, DC 30 V for a

resistive load.

Do not apply a load that exceeds this rating.

XMV4280/XMV4140/XMV4280-D/XMV4140-D Owner's Manual

Connections and Setting Up

Power off

Closed

Open

Lit

Unlit

Lit