Yamaha XS350 소유자 매뉴얼 - 페이지 10
{카테고리_이름} Yamaha XS350에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha XS350 15 페이지. Power amplifier
Yamaha XS350에 대해서도 마찬가지입니다: 서비스 매뉴얼 (28 페이지)
페이지 인쇄
- 1. Power Amplifier
- 2. Table of Contents
- 3. Controls and Functions
- 3. Front Panel
- 3. Rear Panel
- 3. Speaker Impedance
- 4. Caution for Speaker Connection
- 5. Rack Mounting
- 5. Mounting in an EIA Standard Rack
- 5. Portable Rack Mounting
- 5. Fixed Installation Mounting
- 5. General Specifications
- 6. Specifications
- 6. Block Diagram
- 6. Dimensions
- 7. Troubleshooting
Rack Mounting
Mounting in an EIA standard rack
If multiple high-power amp units are mounted in a rack with poor ventilation, the heat from the amps will cause the
interior of the amp to become very hot, causing the performance of the amps to be impaired. In particular, when
mounting in a rack whose back can not be left open, mount according to the following instructions.
Rack: Leave a gap of 10 cm or more between the rear panel of the rack and the rear panel of the amplifier.
Fan: Use a fan with 1.5 m
Mounting: Install the fan kit on the top slot or the top panel of the rack and install a blanking panel between two
amps.
Example of mounting
The figure on the left below shows an example of a fan kit (panels and two fans) on the top slot of the rack. The fans
are Minebia 3115PS-12T-B30 (with 0.9 m
The figure on the right below is a dimensional diagram of a panel on which two 3115PS-12T-B30 are installed.
Fan kit
XS350/XS250
Blanking panel
XS350/XS250
Blanking panel
XS350/XS250
10
3
/min or more maximum wind and 5 mmH
3
/min maximum wind and 5 mmH
O or more maximum static pressure.
2
O maximum static pressure).
2
78
71.5 0.1
248
463
480
Unit: mm