Ecoplus SWBH 26 설치 지침 매뉴얼 - 페이지 15

{카테고리_이름} Ecoplus SWBH 26에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ecoplus SWBH 26 20 페이지. High temp heat pump

Ⅸ.Installation instructions

Installation instructions

1. Unit installation

1).Installation location

Host unit

²Should be installed in a larger & well-ventilated place.

²Installation location should ensure unhindered access outlet (inlet & outlet shown as

below).

²Install gutter or set up positions near the outfall, to facilitate the drainage.

²The installation base or bracket should be steady, to ensure the smooth operation of

running units.

²Make sure the unit is vertical after installation, and no incline.

²Make sure not to install the host unit in the any conditioner of pollution, corrosive gases,

sun and fallen leaves, etc.

²Installation location must not next to place of incendive , easy-explosion and fire .

²Installation must pay attention to the distance between the barriers shown in below

picture (pay attention to arrow direction).

Water tank

²Water tanks should be placed where ambient temperature is above 0℃ .

²Can be installed outdoors or the top of the building (based on the size of water tanks and

the load-bearing capacity of the building and so on).

²Do not install water tanks in the pollution, corrosive gases place.

2).Unit installation

²Units base can be installed as cement concrete structures, steel brackets can also be used,

add the shockproof rubber pads , make the base surface flat.

²Units can be designed based on the working performance.

(See table of technical performance parameters)

²Unit should have drain or drainage inlets.

²Normally required to install in the place where setted cement concrete base.

2000mm above the top

Air outlet

Air inlet

Heat pump

Above 1000mm

Air inlet

Above 1000mm

Water heater