Yamaha ATS-1010 소유자 매뉴얼 - 페이지 12
{카테고리_이름} Yamaha ATS-1010에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha ATS-1010 20 페이지. Front surround system
Yamaha ATS-1010에 대해서도 마찬가지입니다: 소유자 매뉴얼 (19 페이지)
페이지 인쇄
Additional Information
Adjust the volume level
Press VOLUME +/– to adjust the volume
level.
Down
The color of qD DTS indicator changes depending on
the adjustable range. Green indicates a lower volume
level, orange a moderate level, and red a higher level.
Note
Note that when the qD DTS indicator is red, the volume is
set to a higher level. Excessive sound may damage your
hearing or bother others.
y
To turn off the volume temporarily, press
MUTE.
To resume the volume, press MUTE again or
press VOLUME +/–.
Adjust the subwoofer level
Press SUBWOOFER +/– to adjust the bass
level.
The color of qD DTS indicator changes depending on
the bass level. Green indicates a minus level, orange a
standard level (default value is 0), and red a plus level.
Using an external subwoofer
Although the unit has a subwoofer built-in, you can use
commercially available powered subwoofer of your
choice. Refer to "Alternative connections" (☞ P. 5).
1
Set the unit to standby mode.
2
Press both the VOLUME – button and
button of the main unit, release the
button first, then release the VOLUME –
button.
This unit is turned on when switching between the
built-in subwoofer and external subwoofer.
The SURROUND indicator lights up as the following
illustration. Check if the setting is correct. (☞ P. 11)
8
En
Audio delay control
You can use this function to delay sound to synchronize
with a lagging video image.
1
Up
2
The color of qD DTS indicator changes depending on
the adjustable range. Green indicates a shorter delay time,
orange a medium delay, and red a longer delay.
3
y
The adjustment mode is canceled if the unit is left for 20
seconds without any operation being performed.
Additional Information
Note
You cannot use the built-in subwoofer and the external
subwoofer simultaneously.
Press and hold AUDIO DELAY
more than 3 seconds to enter
adjustment mode.
Flashes in green (☞ P. 11)
Press SUBWOOFER +/– to adjust the
delay time. (+ increases the delay time)
Make the delay time longer
Make the delay time shorter
Press AUDIO DELAY to exit the
adjustment mode.
Built-in
subwoofer
The SURROUND
indicator (for 2
seconds after the
unit is turned on)
Green
• The default setting is playback of the built-in
subwoofer.
• You can verify the current setting by turning the
unit on again from standby mode.
External
subwoofer
No light