Yamaha ATS-1050 소유자 매뉴얼 - 페이지 8

{카테고리_이름} Yamaha ATS-1050에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Yamaha ATS-1050 43 페이지. Front surround system
Yamaha ATS-1050에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

Connections

Connect to a TV (or other peripheral device).

CAUTIONS

• Do not connect the power cable of the sound bar to the AC wall outlet before making

connections.

• Do not use excessive force when inserting the cable plug. Doing so may damage the

cable plug or terminal.

Connect the TV and sound bar with the optical

cable (supplied).

Remove the cap of the optical cable and check the

direction of the plug.

Connect the power cable of the sound bar to an

AC wall outlet.

Set the TV as follows.

• Set the TV volume to minimum.

• Disable the TV built-in speaker output (if available).

HINT

• If a setting to disable the speaker output is not available on your TV, you may disable it

by connecting headphones to the headphone jack on the TV. For details, refer to the

manuals of the TV.

• The TV and BD/DVD input jacks support the following audio signals.

− PCM (2 channel)

− Dolby Digital (up to 5.1 channel)

Sound bar (rear)

Power cable

To AC wall outlet

Optical cable

HDMI cable (etc.)

Playback device

(such as a BD player)

Set top box

BD/DVD

ANALOG SUBWOOFER OUT

OPTICAL OUTPUT

HINT

In the following cases, connect the coaxial digital

audio output of the playback device to the BD/DVD

input of the sound bar with a coaxial digital cable

(commercially available), then select the BD/DVD

key on the remote control for the input source.

− The TV does not have an optical output.

− The TV does not output audio (or outputs low

volume audio) from the connected playback

device.

− The audio from the playback device connected to

the TV cannot be heard as surround sound.